『Turbine flowmeter factory』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
How to install a turbine flowmeter correctly? Hello, KNKE, a manufacturer of turbine flow meters imported from the United States, is pleased to answer your question.
1、 Turbine flow meters can be installed horizontally or vertically. When installed vertically, the fluid flow direction should be from bottom to top, and the liquid must fill the pipeline without bubbles. The direction of the flow of hail should be consistent with the direction indicated by the arrow on the sensor housing. The upstream end should have at least a certain length of straight pipe section, with smooth, clean and tidy inner walls, and no defects such as dents, accumulation, peeling, etc. 2. The axis of the sensor tube should be aligned with the axis of the adjacent pipeline. The gasket for connecting the seal must not penetrate deep into the pipe. Sensors should be kept away from external electric and magnetic fields. Effective shielding measures should be taken when necessary to avoid external interference.
3、 It is recommended to install a bypass pipeline at the location where the turbine flowmeter is installed to avoid affecting the normal flow of liquid during maintenance.
4、 When impurities are present in the fluid, a filter should be installed with a mesh size of 20-60 mesh depending on the flow rate of impurities. When free gas is mixed in the fluid, an air purifier should be installed, and the entire pipeline system should be well sealed. Users should fully understand the corrosion situation of the measured medium and strictly prevent the sensor from being corroded.
5、 When impurities are present in the fluid, a filter should be installed. Users should fully understand the corrosion situation of the tested
6、 The installation method of flow meters on pipelines: Installing them on horizontal pipelines is a common installation method for flow sensors. When measuring liquids with a turbine flowmeter, if the measuring body contains a small amount of gas, the sensor should be installed at a lower position in the pipeline. The above is the answer from the American imported turbine flowmeter manufacturer, KNKE, on how to correctly install the source skin for turbine flowmeters. If you want to learn more about turbine flowmeter information, please visit the official website of KNKE in the United States.
2. What are the requirements for the installation site of turbine flow meters?
Hello, the American imported turbine flow meter manufacturer - Kodo Luan Enke KNKE is pleased to answer your question.
.1、 The turbine flow sensor should be installed in an environment that is easy to maintain, with no vibration damping, strong electromagnetic interference, or thermal radiation in the pipeline.
2、 Horizontal installation of sensors requires that the pipeline should not have any visible tilt (generally within 5 °), and vertical installation of sensors should also have a verticality of less than 5 °. In places where flow cannot be stopped, bypass pipelines and reliable valves should be installed, and during measurement, it should be ensured that there is no dripping or leakage in the bypass pipeline.
3、 At the location of the sensor installed on the newly laid pipeline, a short pipe should be connected at one end to replace the sensor. After the pipeline is installed and purged, the sensor can be formally connected.
4、 If there ar
Hot News
Related AD
